VESC A box

Hover · click · blue opens linked boxes · GitBoat v10.5 A7 · Boat 1 only

IN CONTROLLER MOTOR screws from belowFloor is the plate C: CAN drop, PG7 on the top side, 6-3/4 in from corner 1. Holes as drilled, spots read off Mike's photo. CXCESNS box, 11.8 x 8.3 x 3.9 in.CAN · PG7 U: UART and kill, PG7 on the top side, 9-3/4 in from corner 1.UART · PG7 + and - PG16 on the top side, minus 3-3/4 in and plus 5 in from corner 1. Which big gland is plus is Claude's pick (Pending 450).Batt + · PG16Batt - · PG16 Control backbone drop into the Flipsky CAN pigtail.CAN (Control)250 kbps Pi A entry 4. Kill on the servo PPM pin, held high by a 10k from COMM 3.3V. Not CAN frames.UART + kill10k to PPM Boat 1 only propulsion ESC on the Control bus. 5-1/8 x 2-11/16 in (130 x 68 mm). Four screws from below into its own holes.Flipsky 75200 Pro V2.0shorted plug5-1/8 x 2-11/16 inJST-PH 8 · JST-GH 5 Replaces the Flipsky maintained power button.Shorted plugIGNITE to BAT+ No precharge fitted (Mike, 2026-09-29). The Blue Sea 6006 makes the first connection.no prechargenot fitted Four Nichicon 1000 uF 63 V glued to the box floor, tails on two WAGO 221-415, a 12 AWG lead to each MGI post.Cap bankNichicon 1000 uFfloor · 2 WAGO 2 AWG pack feed through the 250 A MEGA.Battery + / - ME1616 Sep 2 position harness into the Flipsky sensor header.SinCos sensorRLS RMB29 · ADC1 ADC2 No ferrite. The phase leads are too short for a clamp.no ferriteleads too short Three PG21 on the motor end, 2-1/4, 4-1/4 and 6-1/4 in from corner 2. The leads come in with their own lugs uncut and bolt inside.U · PG21V · PG21W · PG21 S: sensor lead, PG7 on the top side, 8-1/4 in from corner 1.S · PG7 sensor CANH CANL power USB Ethernet UART I2C GPIO coax SPI RF (wireless) SinCos
Status notes
  1. Cap board Not decided

    Cap board (open 417)

  2. Box plan Decided

    VESC A box plan, as drilled 2026-11-06. Plus and minus PG16 and C, S, U PG7 are on the top side. Three PG21 on the motor end pass the lugs uncut and bolt inside. Posts are screwed from inside. Caps and WAGOs sit along the side away from the glands. Build Guide 5.1: a divider is always fitted on each signal, 10k from the sensor and 20k to ground, and no filter capacitors. As built: Box Plans v10.5/VESC A Box v10.5.pdf. The Boat 2 drilling template is Old/Flipsky Hole Pattern 2026-10-26.pdf.