Release Node B

House bus end · stern · GitBoat v10.5 A15 · terminator on this tee · no bond stud · horn-B drogue channels

Status notes
  1. Box plan Decided

    Release Node B box plan. The feeder leaves the backup-fed bar (line 2).

    Release Node B plan v10.5. Header 3.3V, GND, CAN RX, CAN TX; CANH to OUT 1, CANL to OUT 2. Plug E: red 3.3 V from 3V3, black GND to 6t, yellow CAN TX from D2, white CAN RX to D10. 22 AWG inside: white CAN H, blue CAN L. Surge 1 = H (white), 2 = L (blue).

    One 14/2 per drogue box, red + and black minus: box 1 red 12t black 13t gland 3; box 2 red 11t black 14t gland 4; glands 3 and 4 are PG11 with sealant. Red on H COM and NO; black on both VIN- and OUT-, labeled HORN 1 RETURN or HORN 2 RETURN. A15 still says the three Nucleo pins are open. D3, D7, D8 and the 14-block strip are plan-only. Pending 567 buy-list and A15 gland write-ins stay proposals.

POWER / COMPUTE RELEASE (2 CHANNELS) LANDINGS straight to lids 5-8 deleted: a 4-hole box Klnuoxj 24 to 5 V 5 A potted converter for the Nucleo and CAN PHY.24 to 5 VpottedKlnuoxj Second release brain on the House bus at the stern.NUCLEO-G431KBscrew carrierfive pins - no expander House drop with Taidacent DIN-rail surge. The CAN board keeps its soldered 4-pin header, with a ready-made 24 AWG plug zip-tied on. Header order is 3.3V, GND, CAN RX, CAN TX. Screws: CANH to surge OUT 1, CANL to OUT 2. Plug leads: red 3.3 V from Nucleo 3V3, black GND to 6t, yellow CAN TX from D2, white CAN RX to D10. Surge IN 1 is white (H) and IN 2 is blue (L). No fuse in the feed.SN65HVD230 + surgeTaidacent RS-12V/2S First key - release bus dead until closed.Enable relay24 V 30 A module Drogue lid B-horn, box 1.MOSFET ch1drogue lid B-1 Drogue lid B-horn, box 2.MOSFET ch2drogue lid B-2 Mini DIN strip - landings under screws, not a gadget.mini DIN stripdrogue 1 / 2 landings Own 12/2 feeder on a 30 A breaker on the backup-fed bar (line 2).2 · 24 V12/2 · 30 A · stud 2 House bus end. Drop from the end tee; molded 120 Ohm on the spare port.1 · House CANend tee · 120 ohm Drogue box 1 horn B. Each horn's channel leaves the box through its own potted gland (an epoxy-sealed wire pass-through) low on the transom, on its own route (rule 8): this one to Release Node B at the stern.3 · Drogue 1 Drogue box 2 horn B. Each horn's channel leaves the box through its own potted gland (an epoxy-sealed wire pass-through) low on the transom, on its own route (rule 8): this one to Release Node B at the stern.4 · Drogue 2 CANH CANL power USB Ethernet UART I2C GPIO coax SPI RF (wireless)