Boat 1 · GitBoat v10.5 · 24 V DC distribution
Main bus plan Decided
Main bus board plan v10.5. The Argodiode spot and the breaker relabels are Electronics plan 7.6. The jumper gauge is not picked. The 2026-10-06 bus drawing is the earlier sheet.
Proposal, Pending 559: the two Argodiode jumpers are 12 AWG, and the short black backup-fed link is 12 AWG, at the next write-in. Electronics plan 7.6 still says 6 AWG. This page does not pick a gauge. Pending 561 still lists a short 6 AWG black on the installed board.
Main bus changes Decided
Pending 517: they draw what the guides already decided (Electronics plan 7.6 and A10; items 487, 489, 490, 501 (e) and (f)); nothing new is decided except Claude's picks below. Both of its shunts sit on the positive side, on the main bus board (sec 7.6). Pending 518, where the Argodiode and the backup-fed bar go, stays open and is not drawn.
Electronics plan 7.6: the Argodiode sits in the open space right of the breakers and left of the minus branch bar, near the top, with the backup-fed bar pair standing below it. The top 5 A breaker labelled CAN is line 1's and comes off as a spare. The breaker labelled Aft is line 6 and is relabelled Switch. Line 15's 5 A breaker is on the backup battery board. The jumper gauge is not picked.
Pending 517: both plans are 3 pages each: the photo with numbered marks; the wiring diagram after the changes, added 2026-11-03 at Mike's ask, "can you add wiring detail image?"; then every new or moved wire, the order of work and the parts. This plan's middle page is headed Main bus board: wiring, page 2 of 3, how it connects after the changes, not to scale, new and moved parts in green.
Power-only map (ethernet omitted). Pack to Class-T on the A9 aft wall, to the Blue Sea 6006, to the 400 A busbars. 24 to 5 V, Pi A only, on the main spine. Click a solid box to open the panel. Dashed boxes are passive. Heater deleted v9.5. Boat 1: single VESC A. Full map: Electronics · CAN · SOURCES.md