Flipsky 75200 Pro V2.0 ยท hole pattern, full size

Print at 100 percent ("Actual size", not "Fit"). The bar at the bottom must be exactly 4 in.

1-9/16 in (40 mm) 4-23/32 in (120 mm) case 2-11/16 in (68 mm) wide case 5-1/8 in (130 mm) long FLIPSKY seen from below (same pattern from above: it is symmetric) battery leads end motor leads end its 4 mounting holes: threaded, blind, in the bottom plate its 4 case screws: hold the case together, not for mounting exactly 4 in when printed right

Pattern 40 x 120 mm, read off Flipsky's own photo of the bottom (130 x 68 mm case, the holes land on round numbers and dead center). Flipsky publishes no drawing. Thread size not on record: likely M3 or M4 (a guess). Oct 26, 2026.

Use (Mike, Oct 26): lay this sheet inside the box where the Flipsky goes, punch the 4 centers, drill to clear the screws (M3 9/64 in, M4 11/64 in), countersink from outside (90 degrees for metric flat heads). 316 flat-heads go up from outside into the Flipsky, before the box is glued to the hull.