Boom-root pocket, made simple

side view lid off, about 1 : 2.9; two top views about 1 : 3.2 · inches back of the nose, inches up from the rootOct 28, 2026 · idea, not decided
10.3 spar1112 PEX18.218.7 boom end19.421.622.427.7 back edge42.645.54748.548.9in up11234567891011121314TOP: CUT 47 IN UP, ON THE ROD LINE (lid side up)9812513TOP: CUT 46 IN UP, THROUGH THE LOWER BOLTS (lid side up)11158
1 Two PEX tubes, 12 in back, ending in the pocket's bottom and top walls.
2 Rectangle lid and four straight G10 strips (1/8 x 3/4 in) under its edge; #10-24 screws into rivet nuts, about 12.
3 Rectangle pocket, 10.3 to 22.4 in back, 42.6 to 48.9 in up. All foam inside it comes out; walls and floor get 2 layers of biax. Foam outside it stays.
4 Rear lug on the spar's back face; rear pin 11 in.
5 Actuator, hanging, on the centerline, rod line 47 in up.
6 Cradle and strap under the motor.
7 Plug on the actuator lead.
8 Boom: the guide's plain box, 1-1/2 in wide, straight taper, only 3 in deep at the root instead of 2-1/2. Its front end starts 18.7 in back, inside the pocket.
9 Link tube: a 1-1/4 in fiberglass tube set in the boom's core when the boom is built, 18.7 to 27.6 in. The spring link rides in it, unchanged.
10 Fully out (gray dashed): the link's back cap reaches 27 in, still inside the tube.
11 Four 1/4-20 316 bolts in through the far skin (flat heads, flush) into threaded inserts set in solid epoxy plugs in the boom root. Nothing on the lid side.
12 Notch: a plain rectangle cut out of the wing's back edge, 22.4 in to the back edge, just big enough for the boom. Cut faces glassed; gasket round the boom.
13 One rod: the link's rod runs on as the pushrod, in a 3/8 PEX liner in the boom.
14 Drain (black) at the low back corner; breather (open circle) at the top.
15 Bedding: thickened epoxy between the boom root and the far skin, with the boom wrapped in release tape and bolted down while it sets. No shaping.