Spring link from cut and drilled bought parts

inchesOct 29, 2026 · proposed, not decided

The change from the Trim Guide's link: two springs instead of one, one for push and one for pull. Then each washer stops against a plain piece of tube glued inside, and nothing needs a lathe. Every part is bought and only cut, drilled or glued.

1G10 tongue, cut and drilled; pinned in the tube2tube, 5/8 in3middle stop, glued4back stop, glued5set-screw coupling to the pushrod6washers, 47spring 1: gives in push8spring 2: gives in pull9pins through the rod, 210rod, 1/4 in113/4 in PEX tube in the boom
1. At rest: solid
2. Pulled back hardrod
3. Pushed forward hardrod

How it gives: each washer is pressed onto the middle stop by its own spring, with a pin through the rod right behind it. Pulled harder than 4 lb, the back pin drags its washer back and squeezes spring 2; the front washer stays on the stop. Pushed, the front pin squeezes spring 1. When the wind eases it springs back. Each spring is squeezed from 2 in to 1.05 in for 4 lb; at the 0.4 in the flap needs to go straight it pushes 5.7 lb, under 1-1/2 times the start. About 5.7 in from the front pin to the end of the coupling.

PartWhat it doesWhere to buy
1G10 tongueFrom the 1/4 in sheet on hand, sanded to about 0.22 in where the actuator's fork goes. Its back half slides into the tube; one 1/8 in pin through tube and tongue holds it.On hand
2Tube, 5/8 in, 0.049 in wall, 316, cut to about 4 inThe body.Amazon, VALVENTO 12 in, 2 pack
3, 4Tube, 1/2 in, 0.049 in wall, 316: two 1/2 in long piecesThe middle stop and the back stop, glued inside the 5/8 in tube.Online Metals (not on Amazon in this wall)
5Set-screw coupling, 1/4 in to 1/4 in, stainlessJoins the link's rod to the pushrod, no threads to cut.Climax RC-025-S, 303 stainless (seller to pick; Amazon has only aluminum ones)
6Washers AN960C416: 0.265 in hole, 1/2 in across, 18-8Four.Aircraft Spruce, $0.21 each
7, 8Springs, 0.48 in across, 2 in long, 4.2 lb per inchTwo, one each way.Penn Tool 03308525, 10 for $13.65
9Dowel pins 1/16 x 3/8 in, 316Two, pressed into holes drilled across the rod.Amazon, 100 pack
Dowel pin 1/8 x 1 in, 316Holds the tongue; cut and sand flush.Amazon, 100 pack
10Rod, 1/4 in 316, about 4-1/2 inOn hand
113/4 in PEX, about 10 inThe link is only 5/8 in across now, so the boom's tube shrinks from the 1 in CPVC.Any hardware store