Flap spring and horn: the three G10 parts, full size

inchesprint at 100 percent

All three from 1/4 in G10. Crosses mark hole centers. The dash-dot line points aft, along the flap. Steps on the next page.

1 in
axle 3/8 inBLIND, 3/16 in deepaft1/8 pin, #31 drill1/8 pin, #31 drillUPPER END PLATE
axle 3/8 inBLIND, 3/16 in deepaftLOWER END PLATE (no pin holes)
axle 25/64 in, through1/8 pin, #311/8 pin, #311/4 in: pushrod clevis3/32 in: bias springaftHORN

Flap spring and horn: build it in 10 steps

Nov 2, 2026
+3/4+1/2-1/2-3/4in from the boom's middle1upper end plate, 1/4 in G102spring coil3blue pin, up from the horn4orange pin, down from the plate5horn6thin washer7lower end plate8axle, in blind holes
  1. Print page 1 at 100 percent. Check the 1 in bar.
  2. Cut: stick the 3 templates on 1/4 in G10. Cut and sand to the line.
  3. Drill every cross, at the size printed beside it.
    End plates' 3/8 in hole: stop at 3/16 in deep.
  4. Pins: tap them in, no glue.
    Orange (upper plate): 11/16 in out. Blue (horn): 5/8 in out.
  5. Axle: cut 1-3/8 in. Round the ends.
  6. Stack, bottom up: lower plate, axle, washer, horn, spring.
  7. Spring: squeeze its legs onto the outside of the blue pins. Clamp.
    Coil gets looser? Flip the spring.
  8. Close: drop the upper plate on, orange pins outside the legs. Unclamp.
  9. Check: twist the horn hard. It slips, then springs back.
  10. Glue only the plates' outer faces into the flap pocket.
    No epoxy on the horn, spring or axle.

Parts: 1/4 in G10 (on hand) · spring 9287K47 · 3/8 in 316 rod B076CMP5J5 · four 1/8 x 1 in 316 dowels B00R1UV7QS · thin 3/8 in 316 washer
Drills: #31, 3/32, 1/4, 25/64, 3/8 in